retail high quality cell phone anti-lost alarm display stand with charging

This elegant Security and high practical mobile alarm holder , with UV surface treatment technology.

Now it was widely used in various types of mobile phones, cameras, MP4 and other Consumer Electronics products.This product has changed the marketing model of the store.

The marketing model upgrade from the traditional "tell" type to the innovative "experiential" type, which allows consumers convenient to choose products and services, but also enhance the enterprise 's performance.

Security alarm holder for mobile are composed of the host alarm system, multi-touch alarm sensor, 3M adhesive and other components.

Simple installation methods, such as installation of alarm installed in display racks or display case, Sensor (alarm probe) adhere to the product.

1) Host Base with Charging Function, Charging monthly , Repeated use.

2)Display Charging Function apply to : Mobile Phone

3)Disconnection Alarm Function: Three Contacts disconnection alarm

4)Low Voltage Alarm Function :Voltage Less 3.3V Alarm ,remind the charging

5)Short Circuit Alarm Function : circuit is short-circuited ,automatic alarm

6)Infrared Remote Control Function : Remote Start and Disarm the Alarm.

7)Installation Method : Double ways in 3mm adhesive or use screws tighten.

  1.Clean the display case, then turn on switch on the bottom of Security alarm holder for mobile host, adhere the bottom of the anti-theft frame with 3M adhesive tape to the exhibit cabinet. Or use two anti-theft screws to connect the cabinet frame and tighten the exhibition (open f the screw hole cover firstly)

2.Connect the charger of Security alarm holder for mobile with the alarm host, the other end into the power socket in preparation for a fixed monthly charge.

3.Tear off the 3 adhesive tape from the Anti-Theft Terminal product display and paste exhibit’s back fastened

4.Tear off 3M adhesive from the sensor probe, stick tight with the obverse of the product

5.Take out the Infrared remote control board , tear off the battery insulation sheet underneath. Press the ON key , the host switch on ,enter the preset alarm status

6.The installation is set up

1,Mobile anti-theft alarm holder/stand host base    1 pcs.

2, Alarm sensor probe    1 set

3, Charger and USB charging cable 1 set

4, Cell phone charging adapter cable 1 pcs

5, Remote control 1 pcs

6 ,Operation Manual 1pcs

7 ,Additional 3M adhesive and screws 1 set